Help with new kitchen

Forums › Kitchen DIY Forum › Kitchen DIY Advice › Help with new kitchen

This topic has 2 voices, contains 1 reply.

Viewing 2 posts - 1 through 2 (of 2 total)
Author Posts
Author Posts
February 9, 2004 at 4:18 pm #5197

Anonymous

This is the most helpful site I have come across since surfing for help in the last 3 hours,

Thankyou!

Can you please help me? I have a 1000mm base unit as a corner base running along a wall on the left. To the right @ 90 degrees from the corner of this base will be my washing machine

(free standing). according to the plans, I have an end support panel within the depth of the worktop, this I am assuming is to close one half of the unit that will not have the door

attached and give it the colour matched finish. what is confusing me is I have been given 2 corner posts one smaller than the other, assuming one is for my wall cabinets where on the

base cabinet do I fit this post? or do I need it at all?

Regards

Ian
February 9, 2004 at 10:32 pm #5201

swifty

You need to fit the

corner fillet to your 1000mm base in order to give room for the door to swing open, the support panel would go behind the corner fillet (on the RHS).
You won’t be able to see the support panel once you’ve installed your washing machine, but it will prevent the washing machine moving behind the corner fillet.
I hope this helps :D

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.