how can i vent my hob extractor fan

Forums › Kitchen DIY Forum › Kitchen DIY Advice › how can i vent my hob extractor fan

This topic has 3 voices, contains 4 replies.

Viewing 5 posts - 1 through 5 (of 5 total)
Author Posts
Author Posts
March 31, 2008 at 8:22 pm #6739

wandango75

hi i ‘m new to the site and i’m just wondering whats the best way to vent my extractor fan through the wall up through the cavity 700 mm then out through the brick .i need to do it this way as i have a ground floor extension and its the only way i can vent it .i’m wondering if there is a flexible pipe or kit that i could try bearing in mind the mortar between the brick joints squishing out to make the cavity narrower.any ideas? :D

April 1, 2008 at 4:24 pm #6740

timfoley

Wandango,

Welcome to our forum.
Try as I may I cannot offer a solution to your quandry other than to ask the ventilation experts on this and to allow others to view their response I will ask them to post a reply on our forum,

Tim
May 20, 2008 at 11:31 pm #6797

wandango75

any ideas :oops:

July 12, 2008 at 8:44 pm #6851

marc1106

WANDA
when faced with somthing like this i usually get into the ceiling void and between joists to nearest outside wall!
easy for me as im usually renewing everything anyway,
the only way i can think of is to remove the internal wall by the reqiured width and height and inset fixed flat ducting using preset angles,this can be purchased at most good hardware stores., Again this method depends on your skill levels. Hope this helps :)

July 14, 2008 at 11:57 am #6852

timfoley

Mark,
Thanks for your answer here.
It’s great to have other installers getting involved on the forum.

TIM
Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.